caster/camber

[nickmuddin]

anyone know how to get this back to proper specs? is there anything on a stock xj front axle that is plumb or does anyone know what angle anything should be on? if some has a stock xj around and wouldn't mind trying to find something that is plumb under there please let me know thanks. need to get this right for measurements for longarms ;D ;D

[burntjeep]

Not 100% but I would take one measure ment from the rear axle making it parralel with the front, don,t really know but the arms will adjust once u find out what to squre the axle with wouldn't the frame b relitively squre too? just some deep thoughts, need more input anyone else help?

[nickmuddin]

need something so i can get my front axle rotated to its proper spec.

[lowrad]

Well the Ghost is stock right now...I'll get some measurements on Sunday....I'll check for something to line it up to also
but you can use that link I put in the LA build to see...do you still have your stock arms
Difference I've noticed between them kinda goes like this
the difference between the lowers I did have that where for a 4.5" lift was 0.5" to go to a 6" lift and same 0.5" for the uppers from stock to the proper length for a 6" lift

[shaner]

if you wanna have a look at the long arms on my jeep and take measurements off them just let me know....my uppers and lowers are adjustable but i seem to have them set pretty good and even though my kit is only a 5.5", I sit as high if not higher as what some ppl seem to be callin' 6.0 and 8.0" lifts....i think ppl base the height of there lift on how much higher it sits from start to finish when they do the homemade lifts or something...ie...old flat dead leafs and coils and factory tires vs. the new height with the lift and mudders. Mine is based on how much higher it sits in comparison to a brand new xj. Thats my only guess anyway....let me know if you wanna have a look.

[rstarch345]

This link might help you out. go.jeep-xj.info/HowtoAlignment.htm